
Finding and keeping a skilled press operator in Lagos, Kano, or Onitsha is genuinely hard. Experienced hands move to a competitor for a small pay rise, and the plant is left with someone who learned the job in a week. The instinct is to blame the crew. The more useful question is why the machine depends so heavily on one person knowing things that were never written down.
The first damage is quiet. Bearings run dry, a gear train starts to whine, and the noise gets ignored because the shift target is still ahead and the speed dial still turns. By the time the metal seizes, the repair is a major job rather than an hour with a grease gun.
The second damage is permanent. Solvent ink left in the anilox cells or the gravure cells overnight hardens in place, and once a cell is blocked or worn at the edges it no longer meters ink correctly. That is not a cleaning problem afterwards; it is a replacement cylinder.
The third damage is the most expensive, because it happens in seconds. An operator who sees a faint patch in the print reaches for the impression screws or the doctor blade holder and tightens hard. Blades then wear out in a few hours instead of weeks, and the extra pressure scores the chrome on a gravure cylinder or polishes away the cell edges on a ceramic anilox roll. From that point on, every metre printed carries a line down the web.
None of that happens because the operator is young. It happens because the plant gave them no written routine and paid them for one thing only — metres out the door.
A checklist taped to the frame beats experience that lives in one person’s head. A twenty-two-year-old with a clear end-of-shift list will look after the press better than a fifteen-year veteran who was never told what to check.
The incentive does the rest. If the bonus is calculated on output alone, pushing speed is the rational choice, and every other cost lands on the owner. That is a management design problem, not an attitude problem.
Start with the routine, written where it is used. Print it, laminate it, hang it at the machine, and keep it short enough to finish in the last twenty minutes of a shift: ink pans washed, guide rollers wiped, oil levels checked, and the outgoing operator signs it before leaving. Care becomes part of the job rather than a favour.
Give the crew proper tools and take the improvised ones away. A locked toolbox per press with torque wrenches, soft brushes, brass scrapers for chrome cylinders, and a chemical or ultrasonic routine for ceramic anilox — brass on ceramic wears the cell edges, so it does not belong there. Heavy hammers and iron bars adjust nothing and damage plenty.
Training pays back faster than recruitment. Thirty minutes each Saturday, walking the machines: how a dry bearing sounds, how a hot one feels on an infrared thermometer rather than a bare hand, how to read ink viscosity on a Zahn cup instead of judging it by eye. Once a week, every week, and the warnings get caught before they become failures.
Then change what the bonus rewards. Output alone teaches the crew to abuse the press. Add material waste, non-planned downtime hours, and passing the shift inspection to the calculation, and the same people start protecting the asset because it now pays them to.
Two safety habits belong in that training from day one. Solvent cleaning happens with gloves, ventilation, and no ignition source anywhere near the tray. And nobody reaches into a roller nip while the line is running — stop it, lock it out, wait for the rollers to stand still.
A press does not fail because the crew is careless. It fails when the routine is missing, the tools are wrong, and the pay only counts metres. Fix those three and an ordinary team will keep a good machine good.
If your plant is losing cylinders and bearings faster than it should, or you are specifying flexo and gravure presses for Nigerian conditions, our technical team would be glad to review your setup.

How to Protect Your

How to Fix Print Def

How Cheap Adulterate

How to Print Recycle